Clear and sanitize procedures
Clear the flash memory
This procedure does not erase or change factory calibration constants.
1. Push the front panel DEFAULT SETUP button to recall the default setup.
2. Push the front panel SAVE/RECALL button.
3. Push the Action option (side bezel) button until Save Setup is selected.
4. Push the Save To option button until Setup is selected.
5. Push the Setup option button until 1 is selected.
6. Push the Save option button to overwrite setup 1 with the default setup.
7. Push the Setup and Save option buttons again to overwrite the next setup
with the default setup. Repeat this step until setup 1 is selected again.
8. Push the front panel CH 1 MENU button, and then push the Coupling option
button until Ground is selected.
9. Push the front panel SAVE/RECALL button.
10. Push the Action option button until Save Waveform is selected. Push the
Save To option button until Ref is selected. Push the Source option button
until CH1 is selected.
11. Push the To option button until RefA is selected. Push the Save option button
to overwrite reference waveform RefA with the null waveform.
12. Push the To and the Save option buttons again to overwrite the next reference
waveform with the null waveform. Repeat this step until reference RefA is
selected again.
13. For TBS and TDS oscilloscopes, insert a USB flash drive into the USB Flash
Drive port on the front of the oscilloscope. For TPS oscilloscopes, insert a
compact flash card into the Compact Flash slot on the front of the
oscilloscope.
14. Push the front panel UTILITY button.
15. Push the Options option button.
16. Push the Printer Setup option button.
17. Push the PRINT Button option until Saves Image To File is selected.
18. For TBS and TDS oscilloscopes, push the File Format option button until
JPG is selected. For TPS oscilloscopes, select BMP instead of JPG.
19. Remove any probes from the BNC front panel connectors.
Declassification and Security Instructions 7
To Next Page
Loading...
Need help?
General
