Tektronix TM 515 User Manual

interface
board, using pins 14 through 28 (both
A and B

To
release them, simply pull the leading edges {left and
sides) of the interconnecting
jacks . For a further descrip-

right) out away from the case .
tion of this see
Option 5 in the Options Section of this
manual . Also refer to each plug-in's
manual for the I/O
assignments of each
pin at the rear interface . Once having

Pull the rear edge of each clamp clear of its pressure
made
interconnections of a specialized nature, it is

ridge and the end cover comes off (see
Fig .
2-2) .
recommended that barrier keys be installed to
ensure
module compatibility
with the wiring .
INSTALLATION
AND PRE-TURN ON
PROCEDURE
Front 8~ Rear Cover Removal

The Single Angle Bail Wire used to hold this cabinet of
instruments at a convenient viewing angle is stored inside
The white plastic pieces located left and right
toward

thefrontcover .Ifdesirable,removeitfromstoragemounts
both ends of this cabinet are the
clamps that hold the

and install according to the
viewing angle desired forthis
covers in place .

package . (See
Fig . 2-3 .)
REV A JAN 1980
Rg . 2-2 End Clamp Detail .
OperatingInstructions-TM515
USE OF BAIL
PULLED
OPEN
zozo-s a
2-3

Tektronix TM 515 Specifications

General

Brand	Tektronix
Model	TM 515
Category	Power Supply
Language	English