4.6 CE Marking
This equipment is in conformity with the CE procedures and marking.
4.7 National Restrictions
In accordance to article 10 of 2014/53/EU we inform you that there may be national restrictions and requirements for
authorization. The requirements for any country may evolve. Teldat S.A. recommends that you check with local au-
thorities for the latest status of their national regulations.
This product is supplied with antennas in order to fulfill the local regulation. Do not choose other antennas. To com-
ply with power limits and RF exposure requirements, the antennas used for this transmitter must be installed so that
people keep a separation distance of, at least, 20 cm.
4.8 Operating Frequency
To check the operating frequencies working in the device, see Appendix RF LTE Specifications on page 28 andRF
GSM/WCDMA Specifications on page 28.
4.9 FCC Statement
4.9.1 Federal Communications Commission Interference
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resid-
ential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference through one of the following means:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
Authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including in-
terference that may cause undesired operation.
This device and its antennas(s) must not be placed or operated in conjunction with any other antenna or transmitter,
except when done in accordance with FCC multi-transmitter product procedures.
4.10 IC Statement
4 Compliance Teldat S.A.
22 Teldat 4Ge Router
To Next Page
Loading...
Need help?
General
