372
P R O G R AMMI N G A ND S E T T I N G S
7 PROGRAMMING AND SETTINGS
All relay programming and adjustment operations may be performed through:
• Personal Computer equipped with ThyVisor Software
• MMI (keyboard and display)
7.1 SW THYVISOR
ThyVisor SW is a “browser” of data (setting, measure, etc..); it implements an engine that is afford
to rebuild the menu set up and the relationships to data concerning all Thytronic protective relays
by means of XML files..
ThyVisor setup
The latest release of ThyVisor can be downloaded free of charge from the www.thytronic.it site
(Products - Software).
[1]
— ThyVisor use
Please refer to ThyVisor user manual for detailed instructions.
The document is available on www.thytronic.it (Product / Software / ThyVisor - Download area).
Note 1 Starting from the 3.5.9 release it is necessary to download and install not only the application setup but the Template setup also. In case off
updating download and install only the new release.
WARNING
For safety reasons each change of rated values (Set \ Base menu) needs an hardware reset.
Any change becomes operating after equipment SwitchOFF/SwitchON action.
Note: The above parameters are higllighted in italics font inside ThyVisor menu.’
XMR-D EQUIPMENT MANUAL
Ed. 2.9 - 02/2021
To Next Page
Need help?
General
