Tineco FLOOR ONE S3 Series User Manual

10
Operation
Preparing for Use
Before rst use, please charge the appliance for 4±0.5 hours (refer to “Charging Instructions” for details).
* Based on results from Tineco lab tests. Lab temperature 39.2°F (4°C) ~ 104°F (40°C).
AUTO MAX
Tips:
• Water mode/Solution mode:
Appliance starts with Water mode by default.
Power on while the appliance is upright, long-
press
AUTO MAX
for 3s to switch between the
two modes.
• Switch to Solution mode:
LED Loop: Blue → Red (use cleaning solution)
• Switch to Water mode:
LED Loop: Red → Blue (use water only)
Press the button and the appliance will start
in AUTO mode by default. Press it again to turn
off the appliance. Switch between AUTO and
MAX mode by pressing the
AUTO MAX
button.
<142°
The appliance will stop working when put uprightly
and start running again when you recline.
* Do not recline more than 142° to protect
against water leakage.
Place the appliance on the charging base
vertically after use for recharge and storage.
Note:
• Selecting the appropriate mode depending on the CWT contents is vital for maximum dirt detection
effectiveness.
• Do not vacuum foamed liquid.
• To vacuum water left on the surface, the appliance will switch off in 3 seconds after power off.
Stop Working Start Again

Tineco FLOOR ONE S3 Series Specifications

General

Brand	Tineco
Model	FLOOR ONE S3 Series
Category	Vacuum Cleaner
Language	English