Installation Instructions Manual
The purpose of this manual is:
1- To provide the installer with the basic directions and recommendations for
the proper installation and adjustment of the water heater.
2- To explain the features, operations and safety precautions of the Titan®
Electronic Tankless Water Heater to the owner-operator.
Installation of a tankless water heater is NOT considered a “do-it-yourself”
project. The installation of a Titan electronic tankless water heater is relatively
simple and can be done by any licensed plumber and electrician contractor.
The instructions are very simple and specic. If your installer has any questions
regarding the installation, he can contact us for assistance. See support page
on our website www.tanklesswaterheater.com.
Be sure to read and understand the entire manual before attempting to install
or operate the Titan Tankless Water Heater. It may save you time and cost. Pay
particular attention to the safety instructions. Failure to follow these warnings
could result in damage to the unit and to property. If you have problems
understanding the instructions in this manual STOP and get help from a
qualied professional or contact customer support.
Keep this manual in a safe place.
Installation
MOUNTING OF TITAN TANKLESS WATER HEATER
Niagara Industries supplies each heater
with a mounting kit containing four (4)
sheet metal screws and two (2) supporting
brackets in a plastic bag.
These brackets can be attached to the back of
the heater and allow the installer to secure the
heater to the wall without the need to open the
front cover.
Make sure to only use the brackets and
screws that are provided in the mounting
kit. The use of longer screws may
damage the unit and void your warranty.
BACK PANEL
UPPER
MOUNT
HOLE
LOWER
MOUNT
HOLE
WALL
MOUNT
BRACKET
To Next Page
Loading...
Need help?
General
