TLD GPU-406 Information And Operating Instructions

Creation: 01.31 - 2014 1-2-1
GPU - 406
GPU
-
409
Operation
1. Preparation for Use
A. Inspection/Check
Inspect the unit thoroughly prior to operation.
(1) Remove the blocking, banding, ties, and other securing material.
(2) Inspect for shipping damage.
(3) Inspect the interior for foreign material such as rags, shipping papers, etc.
(4) Check the fuel, coolant and oil hoses and connections for visible leaks. For Tier 4 Final engines,
check the DEF fluid lines.
(5) Check the following for sufficient quantity.
(a) Fuel
The level gauge should be at or near full.
(b) Engine Coolant
Coolant level should be approximately one inch below the radiator filler neck. The expansion
tank should be approximately half full. See engine manufacturer’s manual (Chapter 5) for
recommended coolant type.
CAUTION:
BEFORE FUELING WITH ANY TYPE OF JET FUEL, CONTACT
TLD. DAMAGE TO THE FUEL INJECTION SYSTEM COULD
RESULT. NEVER USE JET FUEL WITH A TIER 4 ENGINE. ONLY
ULTRA LOW (<15PPM) SULPHUR DIESEL CAN BE USED WITH
WARNING:
IMPROPER OPERATION CAN KILL! READ AND UNDERSTAND
ALL OF THE OPERATING INSTRUCTIONS BEFORE
ATTEMPTING TO OPERATE THE UNIT.
CAUTION:
BE SURE THE COOLANT SYSTEM ANTI-FREEZE SOLUTION IS
ADEQUATE TO PROTECT BELOW THE LOWEST
TEMPERATURE EXPECTED.

TLD GPU-406 Specifications

General

Brand	TLD
Model	GPU-406
Category	Portable Generator
Language	English