1718
5. TROUBLESHOOTING
6. STORAGE
If the plate compactor is being stored for more than 30 days:
6.1 Storage Tips
6.1.1 Remove loose stones and dirt from plate.
6.1.2 Clean engine cylinder cooling fins.
6.1.3 Clean or replace air filter.
6.1.4 Change exciter oil.
6.1.5 Change engine oil and follow stroage procedures described in the engine manual.
6.1.6 Cover plate and engine and store in a clean, dry area.
Problem / Symptom Reason / Remedy
Plate does not develop full speed,
not moving
Poor compaction
A) Engine throttle control is not completely open.
B) Throttle control is not adjusted correctly.
C) Ground is too wet, plate sticking. Allow soil to dry
before compacting.
D) Drive belt is loose or worn, slipping on pulleys. Adjust
or replace belt. Check that the engine mounting bolts are
tight.
E) Exciter bearings binding. Check condition
and level of
oil in exciter. Add or change oil.
F) Air filter is clogged with dust, reducing engine
performance. Clean or replace air filter.
G) Engine speed is too low. Check the engine speed with
tachometer. Adjust or repair engine to run at correct the
speed. Refer to engine manual.
H) Check hydraulic lines. Clear lines or air.
Engine running, no vibration
Engine throttle is not open.
Drive belt is
loose or broken. Adjust or replace.
Clutch is damaged. Inspect and replace clutch.
Engine speed is low. Check engine speed.
Too much oil in exciter. Adjust oil to the correct level.
Plate jumps or compacts unevenly
Ground surface is too hard.
Shockmounts loose or damaged.
To Next Page
Loading...
Need help?
General
