5. ADDING CHEMICALS
Avoid direct contact with chemicals and always follow the instructions of the chemical
manufacturer. Always wear the proper clothing and chemical protection. Its important to
dilute your chemicals according to the chemical manufacturers specifications. Never spray
undiluted chemicals. Dilute and prepare your chemicals prior to turning on your fogger.
Prepare your chemical and pour into the mist blower water tank outdoors or in a well
ventilated area. Aer spraying, do not keep the spray solution in the tank. Properly dispose
of the excess spray solution and rinse your machine aer each use.
5.1 Adjusting Options
5.1.1 Droplet Size
To adjust droplet size use the water valve
to increase the flow of water from the
tank. Turn the knob counter- clockwise
for a smaller droplet size and clockwise
for a larger droplet size. See Figure 5.
5.1.2 Water Speed
To adjust the speed of water use the throttle handle to increase the engine’s speed.
See Figure 2.
5.1.3 Water Flow
To adjust water flow use the water valve to increase the flow of water from the tank.
See Figure 1.
6. CARBURETOR ADJUSTMENT GUIDE
12
Some chemicals sprayed with the fogger can contain toxic substances which
can lead to serious side effects and injury.
FIGURE 5
2
Identify the engine’s carburetor in between
the engine cover and air filter.
1
If your fogger engine is bogging down or only
runs with the choke open, follow these steps.
To Next Page
Loading...
Need help?
General
