4.1 Start Up Guide Continued
4.2 Sprayer Operation
4.2.1 Attach your desired nozzle or spraying attachment to the hose.
4.2.2 Start the engine using the guide above.
4.2.3 Adjust the engine speed using the throttle on the le side of the engine.
4.3 Stopping the Engine
4.3.1 Stop spraying to interrupt the flow of liquid pesticide.
4.3.2 Move the Throttle Lever up to the idle position.
4.3.3 Press the Red Stop Button located above the throttle handle.
4.3.4 Move the choke to the closed position.
4.3.5 Remember: Do not run the motor without liquid in the tank, as this can ruin the
bearings in the pump which are water cooled.
10
3
Prime the fuel injection pump
3-5 times.
4
Slowly pour your liquid into the
chemical tank.
5
Place the choke down into the
closed position .
6
Pull the recoil starter 1-3 times
until the engine is starts.
7
Place the choke up into the
open position.
8
Maintain the engine running on idle
for 3-5 minutes before spraying.
WARNING
Do not allow the recoil starter to snap back against the engine.
Return it gently to prevent damage to the starter.
To Next Page
Loading...
Need help?
General
