TomTom LINK 300 User Manual

5
Resetting TomTom Remote LINK
If your Remote LINK is paired with a device but not working properly, or if your
Remote LINK is paired with the wrong device, you can reset the device to the
default factory settings.
1. Press any button on your Remote LINK to switch it on.
2. Press any two buttons at the same time until you hear a sound.
Your Remote LINK switches off.
Note: To check if the reset was successful, press any key on your Remote LINK
to switch it on.
If the yellow LEDs on all three buttons are flashing, then the reset was
successful.
If the blue Connection LED is on, then the reset was not successful.
To reset your Remote LINK, repeat steps 1 to 2.
Resetting TomTom LINK 300/310
If you want to pair your LINK 300/310 to a different Remote LINK, you need to
reset the LINK 300/310. To reset the LINK 300/310, delete the Bluetooth
address for the Remote LINK for the corresponding vehicle in the
configuration dialogue in TomTom WEBFLEET and click "Save changes".

TomTom LINK 300 Specifications

General

Brand	TomTom
Model	LINK 300
Category	GPS
Language	English