10
Perfect Heat System
WARNING! The Perfect HeatTM Plus System can produce very hot water that could damage some deli-
cate fabrics and bers. Please ensure the surface being cleaned will not be damaged by hot water up to
200 degrees Fahrenheit.
This machine is equiped with the Perfect HeatTM Plus System for heating the cleaning solution. This system
uses a combination of the patent pending Perfect HeatTM coils and an inline electrical heater.
Operation:
1. Follow operating instructions steps for lling the machine with water and cleaning solution.
2. Turn on electrical heater, switch is located on panel.
3. Pre-heat machine for 5-10 minutes before use.
NOTE: There is a valve in the upper compartment that either sends the water through the heating compo-
nents, or bypasses them. The machine is preset in the “HOT” position. To clean with cold water, turn the valve
to “COLD” or UP position. This should be done prior to lling the tank with water. For general
cleaning, it is recommended leaving the valve in the “HOT” or down position and cleaning with hot water.
Valve
To Next Page
Loading...
Need help?
General