11
MAINTENANCE
Daily Maintenance
To maintain optimum performance the equipment, tools and lters should be cleaned after each use. Re-
place any lters that cannot be cleaned or are damaged. Nozzles that cannot be cleared should be discard-
ed. Wipe down the equipment with a damp cloth to keep clean and preserve the appearance.
1. Wands and Tools
Rinse opening of tool with water to eliminate any debris.
Wand only – open and clean in-line strainer.
A. Disconnect the In-line Strainer by using the quick disconnect coupler.
B. Remove the lter and rinse with water.
C. Remove any debris from the strainer.
D. Keep o-ring and threads of the plug lubricated.
DEFOAM is a good lubricant or use a non-petroleum based lubricant. This will ensure a tighter seal.
Wipe tool with damp cloth and store with head up to prevent clogging of nozzle.
Inline Strainer Filter
Quick Disconnect
Coupler
2. Filters
In-Line Strainer Filter – Disconnect the In-line Strainer Filter on the wand by using the quick disconnect
coupler. Remove the lter and rinse with water. Remove any debris from the strainer. Keep o-ring and
threads of the plug lubricated. DeFoam is a good lubricant or use a non-petroleum based lubricant.
This will ensure a tighter seal.
Inlet Filter – Remove the inlet lter. Dump and clean debris at the end of each cleaning job.
Main Filter – Remove the main lter sleeve and rinse out and clean thoroughly.
Pump Protection Filter – This ball-shaped lter should be in place when the tank is cleaned and rinsed.
Remove and rinse only after the tank is rinsed.
To Next Page
Loading...
Need help?
General