1. The air pressure needed is determined by the
payload carried.
2. The lower the air pressure, the less the
compaction and tire marks are minimized. Lower
pressure should not be used for heavy payloads at
high speeds. Tire damage may result.
3. Higher pressures should be used for heavier
payloads at higher speeds. Do not exceed the
maximum pressure. Use the following charts to
determine correct tire pressures for tire size and
payload of vehicle.
When replacing vehicle tires, only
use replacements approved for the Workman
®
.
Use of tires not approved may cause turf damage
or accelerated drive train damage.
Check Brake Fluid (Fig. 16)
The brake fluid reservoir is shipped from the factory
filled with “DOT 3” brake fluid. Check level before
engine is first started and every 8 hours or daily,
thereafter.
1. Park machine on a level surface.
2. Fluid level should be up to FULL line on
reservoir.
3. If fluid level is low, clean area around cap,
remove reservoir cap and fill to proper level. DO
NOT OVERFILL.
Figure 16
1. Brake fluid reservoir
2. Full line
2
1
Maximum Total Axle Weight (lb.)
(thousands)
23” FRONT TIRES
Tire Pressure (p.s.i.)
Maximum Total Axle Weight (lb.)
(thousands)
20” FRONT TIRES
Tire Pressure (p.s.i.)
Important
19
To Next Page
Loading...
Need help?
General
