5. Install the new blade and all mounting hardw are ( Figure
33 ).
Important: P osition the cur v ed ends of the blade
to point to w ard the mo w er housing .
6. Use a torque wr ench to tighten the blade bolt to
60 ft-lb (82 N ⋅ m).
Important: A bolt torqued to 60 ft-lb (82 N ⋅ m)
is v er y tight. W hile holding the blade with a block
of w ood, put y our w eight behind the ratchet or
wr ench and tighten the bolt secur el y . T his bolt is
v er y dif ficult to o v er tighten.
Cleaning the Mower
T he mo w er may dislodge material fr om under the
mo w er housing .
• W ear ey e pr otection.
• Stay in the operating position (behind the
handle).
• Do not allo w bystander s in the ar ea.
1. With the engine r unning on a flat pa v ed surface , spra y a
stream of w ater in front of the right rear wheel ( Figure
34 ).
T he w ater will splash into the path of the blade , cleaning
out the clippings .
Figure 34
2. W hen no more clippings come out, stop the w ater and
mo v e the mo w er to a dr y area.
3. R un the engine for a few min utes to dr y the housing
to prev ent it from r usting .
Storage
Store the mo w er in a cool, clean, dr y place .
Preparing the Mower for
Storage
Gasoline v apor s can explode.
• Do not stor e gasoline mor e than 30 days.
• Do not stor e the mo w er in an enclosur e near an
open flame.
• Allo w the engine to cool bef or e storing it.
1. On the last refueling of the year , add fuel stabilizer to
the fuel as directed b y the engine man ufacturer .
2. Dispose of any un used fuel properly . R ecycle it
according to local codes , or use it in y our automobile .
Note: Old fuel in the fuel tank is the leading cause of
hard star ting . Do not store fuel without stabilizer more
than 30 da ys , and do not store stabilized fuel more than
90 da ys .
3. R un the mo w er until the engine stops from r unning
out of fuel.
4. Prime the engine and star t it ag ain.
5. Allo w the engine to r un until it stops . W hen y ou can no
long er star t the engine , it is sufficiently dr y .
6. R emo v e the wire from the spark plug and connect the
wire onto the retaining post.
7. R emo v e the spark plug, add 1 oz. (30 ml) of oil through
the spark plug hole , and pull the star ter rope slo wly
sev eral times to distribute oil throughout the cylinder to
prev ent cylinder cor rosion during the off-season.
8. Loosely install the spark plug .
9. Tighten all n uts , bolts , and screws .
Folding the Handle
F olding or unf olding the handle impr oper l y can
dama ge the ca bles, causing an unsafe operating
condition.
• Do not dama ge the ca bles when f olding or
unf olding the handle.
• If a ca ble is dama ged, contact an Authoriz ed
Ser vice Dealer .
12
To Next Page
Loading...
Need help?
General
