Setup
Important: R emo v e and discard the pr otecti v e
plastic sheet that co v er s the engine.
1. Unfolding the Handle
F olding or unf olding the handle impr oper l y can
dama ge the ca bles, causing an unsafe operating
condition.
• Do not dama ge the ca bles when f olding or
unf olding the handle.
• If a ca ble is dama ged, contact an Authoriz ed
Ser vice Dealer .
1. Carefully mo v e the upper handle forw ard until the
handle halv es are in line and nest tog ether as sho wn
( Figure 3 ).
Figure 3
2. Tighten the handle knobs ( Figure 4 ).
Figure 4
3. R otate the handle rearw ard (as sho wn) until it clic ks
into place ( Figure 5 ).
Figure 5
2. Filling the Engine with Oil
Y our mo w er does not come with oil in the engine , but it
does come with a bottle of oil.
1. R emo v e the dipstic k ( Figure 6 ).
Figure 6
2. Slo wl y pour oil into the oil fill tube until the oil lev el
reac hes the Full line on the dipstic k ( Figure 6 ). Do not
o v erfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30W
deterg ent oil with an API ser vice classification of SF ,
SG , SH, SJ , SL, or higher .)
3. Install the dipstic k securely .
Important: Change the engine oil after the fir st 5
operating hour s ; change it y ear l y ther eafter . R efer
to Changing the Engine Oil.
3. Installing the Fuse
Model 20067 onl y
Y our mo w er comes with a 40-amp fuse that protects the
electric star ter .
Important: Y ou cannot star t the mo w er with the
electric star ter or charge the batter y unless y ou install
the fuse.
1. Unclip both ends of the batter y co v er and remo v e it
( Figure 7 ).
6
To Next Page
Loading...
Need help?
General
