Sensor Connection and Operation:
The DDCWP will respond to a Toro, TRS wired Rain Sensor™. Cut the
yellow looped wire from the controller, and using waterproof connectors,
connect the two wires from the rain sensor to either ends of the yellow
controller wires.
The controller will respond to any normally closed (N.C.) rain sensor.
Follow the manufacturers installation instructions.
Activation of the rain sensor cancels irrigation programs until the rain
sensor returns to a closed status.
NOTE: When irrigation is suspended due to the rain sensor,
the display shows: and the rain icon is displayed.
Dial position: WATER BUDGET (Seasonal adjust)
In this dial position you can increase or decrease the
RUN TIME of all stations in that program by percentage
scaling from 0% to 200% in 10% increments.
Press PROG to select the program you wish to scale.
Press +/ON or -/OFF to change.
The Initial RUN TIME represents 100%. The controller will record the
change, i.e., if a program was scaled down to 80%, next time you enter
this dial position the display will show 80%.
To set a program to "OFF"
If you wish to stop irrigation of a program, set percentage scaling to 0%.
The display will show that program is OFF.
To resume normal operation of that program, Dial to "WATER BUDGET"
and increase the percentage to your desired value. Increasing to 100%
will set RUN TIME to its original value.
Press PROG to select the program.
Press DIAL to advance to MANUAL.
Dial position: MANUAL
The MANUAL mode allows immediate customized
irrigation on one or more zones. You can set an
individual RUN TIME for each of the stations you wish
to start manually. The controller has a "programmable manual" function, so
if you manually operate more than one station, they will open in sequence.
Press +/ON or -/OFF to set the station RUN TIME.
Press NEXT to advance to next station.
To turn ON the 1st station in the sequence:
Press DIAL to AUTO-RUN position.
Press -/OFF (in AUTO-RUN position) to turn OFF the sequence.
All stations with a manually programmed RUN TIME will be displayed.
Operating stations will flash and the display will show the remaining RUN
TIME of the station (count down).
Press DIAL to advance to MANUAL PROGRAMS.
- 8 - - 5 -
To Next Page
Loading...
Need help?
General
