Need help?Do you have a question about the Toro Lynx SmartHub and is the answer not in the manual?
General| Brand | Toro |
|---|---|
| Model | Lynx SmartHub |
| Category | Lawn and Garden Equipment |
| Language | English |
Guide for mounting the Lynx SmartHub cabinet on a vertical wall or other sturdy structure.
Details on preparing the foundation hole and pouring concrete for pedestal installation.
Procedure for connecting new communication cables for Lynx Smart Modules in a new system.
Procedure for connecting new communication cables for GAC decoder modules in a new system.
Instructions for connecting a status sensor to the SmartHub motherboard terminals.
Instructions for connecting a rain sensor to the SmartHub motherboard terminals.
Instructions for connecting a flow sensor to the SmartHub motherboard terminals.
Instructions for connecting a master valve or pump relay to the SmartHub motherboard.
Describes the local wiring setup for communicating with the SmartHub via wireline.
Explains the three operating modes: Central, Local, and Off for the SmartHub controller.
Guide to navigating menus and editing values using the SmartHub's interface.
Setting the SmartHub's operating mode between Central, Local, or Off.
Suspends satellite operation for a specified duration.
Suspends satellite operation and watering due to rain.
Resets all irrigation programs to their default settings.
Resets all individual station settings to their default values.
Resets all user-defined program data and configuration values.
Accessing and configuring sensor inputs for Rain, Status, or Flow.
Selecting the daughterboard (1 or 2) for station settings.
Selecting the station to edit within the SmartHub's station count.
Setting the percent adjust for an individual selected station.
Entering or changing decoder module addresses downloaded from Lynx.
Displaying express group numbers assigned to a station for express tests.
Displays total scheduled station runtime for the current irrigation day.
Displays total station runtime that occurred for the current irrigation day.
Displays total station runtime that occurred for the previous irrigation day.
Disabling or enabling station operation; countdown occurs if disabled.
Skipping scheduled operations for a station for a specified period.
Configuring a station output to function as a switch, not affecting pump output.
Details how watering lists are used in Central Mode; programs are not editable.
Guide to creating irrigation programs with various settings in Local Mode.
Manually activating an entire irrigation program.
Activating stations for a specified runtime for additional watering.
Monitoring communication network traffic and status.
Monitoring all SmartHubs within the system.
Displaying the SmartHub firmware version and creation date.
Checking detected stations, sensors, power-down/up times.
Displaying alarms generated by communication failures with stations.
Displaying time, date, current, and voltage of the last activated station.
Displaying real-time sensor information for enabled sensors.
Monitoring SmartHub's amperage, voltages, and temperature.
Indicates overheating, shuts off and disables daughterboard indefinitely.
Triggered when load current exceeds 1.0 Amps.
Triggered when load current on one wire is 2x higher than the opposite wire.
Instructions on how to clear active alarm conditions.
Technical specifications for the radio equipment.
Details on power supply fuses and circuit breaker ratings.
Key specifications for the SmartHub cabinet, controls, and power.
To Next Page