Toro Power Clear 621 User Manual

SPECIFICATIONS & MAINTENANCE
2-17
Toro Single Stage Snow Service Manual
Specications & Maintenance
2
Changing the Engine Oil
Service Interval
• After the rst 2 hours
• Yearly
Run the engine a few minutes before changing the
oil to warm it. Warm oil ows better and carries more
contaminants.
1. Siphon the fuel from the fuel tank into an approved fuel
container, or run the engine until it stops.
2. Move the machine to a level surface.
3. Place an oil drain pan under the oil drain plug, remove
the oil drain plug, and tip the machine backward and
drain the used oil in the oil drain
pan (Fig. 013).
4. After draining the used oil, return the machine to the
operating position.
5. Install the oil drain plug and tighten it securely.
6. Clean around the oil ll cap (Fig. 014).
Inspecting the Rotor Blades
Service Interval
Yearly – Inspect the rotor blades and replace the rotor
blades and scraper if necessary.
Before each session, inspect the rotor blades for wear.
When a rotor blade edge has worn down to the wear
indicator hole. Replace the rotor blades and the
scraper (Fig. 012).
Fig. 013
A
B
Fig. 012
A. The wear indicator hole is intact; you do not need to
replace the rotor blades.
B. The wear indicator hole is exposed; replace the
rotor blades.

Toro Power Clear 621 Specifications

General

Brand	Toro
Model	Power Clear 621
Category	Snow Blower
Language	English