Toro Power Clear 621 User Manual

SPECIFICATIONS & MAINTENANCE
2-20
Toro Single Stage Snow Service Manual
11. Set the gap on the plug to 0.030” (0.76mm)
(Fig. 019).
12. Install the spark plug and torque it to 20–22 ftlb
(27–30 Nm).
13. Connect the wire to the spark plug.
NOTE
Ensure that the breather tube is routed above the spark
plug wire as shown in Fig. 020.
A. Center Electrode Insulator
B. Side Electrode
C. Air Gap (not to scale)
B
A
C
D
Fig. 019
14. Remove the fuel tank cap.
15. Install the shroud with the screws you removed in
step 4.
NOTE
Ensure that the upper and lower shrouds t together in the
side grooves.
16. Install the fuel tank cap.
17. Install the chute seal, the discharge chute, and the
discharge chute handle onto the machine using the
hardware you removed in step 3.
NOTE
The small screw goes through the small hole in the chute
seal at the front of the discharge chute opening.
A
B
Fig. 020
A. Breather tube B. Carburetor drain bolt

Toro Power Clear 621 Specifications

General

Brand	Toro
Model	Power Clear 621
Category	Snow Blower
Language	English