8
Set up
Preparation
Basic Operation
Advanced Operation
Reference Section
Preparing the Remote Control for Use
With the Remote Control, you can operate your TV, most VCR models, and cable TV converters together, even if they are
different brands. If you will be using your TV with a Toshiba VCR, your Remote Control is already programmed and ready
to use. If you own different brands of VCR's and/or converters, you first have to program your Remote Control.
(See “Programming the Remote Control” on page 11.)
Installing the Remote Control batteries
1 Slide the battery cover off of the back of the Remote Control.
Caution:
●
Dispose of your batteries in a designated disposal
area. Do not throw your batteries into a fire.
●
Do not mix battery types or combine used
batteries with new ones.
●
Remove dead batteries immediately to prevent
battery acid from leaking into the battery
compartment.
●
If you do not intend to use the remote control for
a long time, remove the batteries.
Note:
This Remote Control’s functions may or may not
operate your VCR or cable TV converter.
Refer to the owner’s manuals supplied with the
equipment to see which features are available. In
addition, the original controllers may have features
not available on this Remote Control. If you would
like to continue to use these features, you may want
to use the original remote control.
Press and slide to remove.
2 Install two “AA” size batteries. Match the + and – signs on the batteries to
the signs on the battery compartment.
3 Slide the battery cover back on to the Remote Control until the lock
snaps.
Preparation
To Next Page
Loading...
Need help?
General
