English - 2 -
3
Connections
Antenna
Connect the antenna cable/s to your TV.
satellite
dish
aerial /
cable TV
HDMI connection
rear side or rear-left
side of TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control. Or press the control
button to display the function options menu and then
press the button consecutively to move the focus to
Source option. Press and hold the button for about 2
seconds to activate this option. The icon colour of the
option changes when activated. Then press the button
once again to display the Sources list. Scroll through
the available sources by pressing the button.
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cord to the mains socket outlet.
socket on.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
Switching on the TV
4
In order to turn the TV on from standby mode:
Press the Standby button, a numeric button,
Programme +/- button, Guide button, button
or Freeview Play button on the remote control
Press the control button on the TV
Internet connection
5
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired
or wireless connection. Refer to full user manual for detailed instructions.
Wired Wireless
wireless
modem/router
Note: The gures are for representation only
To Next Page
Loading...
Need help?
General
