operating your computer away from an AC power source for an extended
period of time.
This section explains how to remove and install the battery pack, and
begins with the removal process which is detailed through the following
steps.
Do not remove the battery pack while the computer is in Sleep Mode,
as data is stored in RAM, so if the computer loses power it could be
lost.
In Hibernation Mode, data will be lost if you remove the battery pack or
disconnect the AC adaptor before the save is completed.
Do not touch the battery release latch while holding the computer or
the battery pack might fall out due to the unintentional release of the
battery release latch and cause injuries.
Removing the battery pack
To remove a discharged battery, do the following:
1. Save your work.
2.
Click the power icon ( ) on the Start screen and then click Shut
down while holding down the SHIFT key. Ensure that the Power
indicator is off.
3. Remove all cables and peripherals that are connected to the
computer.
4. Close the display panel and turn the computer upside down.
5. Slide the battery lock into its unlocked (
) position.
6. Slide and hold the battery release latch to disengage the battery pack
and then lift it up to remove it from the computer.
Figure 4-5 Releasing the battery pack
1. Battery lock
3. Battery pack
2. Battery release latch
Installing the battery pack
To install a battery pack, do the following:
User's Manual
4-23
To Next Page
Loading...
Need help?
General