■
Under ceiling type
Vertical adjustment
T When cooling
Point the louver horizontally to send cool air across the
entire room.
T When heating
Point the louver downward to send heated air to the
floor.
• The louver automatically closes when running is
stopped.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote
controller even in pre-heating mode, but the actual
swing starts only after pre-heating is complete.
Horizontal air flow adjustment
To change the horizontal air flow direction, point the
vertical louvers inside the horizontal louver in your
preferred direction.
NOTE
• When the horizontal louver is pointing downward in
COOL mode, water droplets may form on the surface
of the cabinet or louver and drop down.
• When the horizontal louver is pointing horizontally
in HEAT mode, the air may not warm up the room
evenly.
■
Floor standing type
Vertical adjustment
T When cooling
Move the louver manually and point it horizontally to
send cool air across the entire room.
T When heating
Move the louver manually and point it downward to
send heated air to the floor.
Horizontal adjustment
T Sending air in different directions
Lift up the vertical louvers slightly and point them in
your preferred directions.
1
2
In this case, do not use the
auto swing function.
How to change the louver angle
①
②
③
④
⑤
⑥
⑦
⑧
Louver
Louver
Vertical louver
The louvers can be adjusted at 8 phases linking with
5 louvers. When changing the louver angle, hold near
the center of louver and move it slowly.
– 12 –
23-EN 24-EN
To Next Page
Loading...
Need help?
General
