’01 L/C U (L/O 0008)
276
Oil type:
Standard differential
Hypoid gear oil API GL−5
Limited−slip differential
Hypoid gear oil for limited−slip differ-
ential API GL−5
Recommended oil viscosity:
Above −18!C (0!F)
SAE 90
Below −18!C (0!F)
SAE 80W or 80W−90
CHASSIS LUBRICATION
Wheel bearings:
Lithium base wheel bearing grease,
NLGI No.2
Front drive shaft thrust bushings:
Synthetic oil and lithium soap base
chassis grease, NLGI No.1
Propeller shafts:
Lithium base wheel bearing grease,
NLGI No.2
BRAKES
Minimum pedal clearance when depressed
with the force of 490 N (50 kgf, 110 lbf)
with the engine running, mm (in.):
116 (4.6)
Pedal free play, mm (in.):
1—6 (0.04—0.24)
Pad wear limit, mm (in.):
1.0 (0.04)
Lining wear limit, mm (in.):
1.0 (0.04)
Parking brake adjustment when pulled with
the force of 196 N (20 kgf, 44 lbf):
4—6 clicks
Fluid type:
SAE J1703 or FMVSS No.116 DOT 3
STEERING
Wheel free play:
Less than 40 mm (1.6 in.)
Power steering fluid type:
Automatic transmission fluid DEXRON
"
II
or III
Tires
Tire size:
P275/70R16 114S
Tire pressure, kPa (kgf/cm
2
or bar, psi):
Normal driving
Front 200 (2.0, 29)
Rear 220 (2.2, 32)
Trailer towing
Front 200 (2.0, 29)
Rear 240 (2.4, 35)
Wheel size:
16 ! 8JJ
Wheel nut torque, N·m (kgf·m, ft·lbf):
131 (13.4, 96.6)
NOTE: For a complete information on tires
(e.g. replacing tires or replacing
wheels), see ”Checking tire pres-
sure” through ”Aluminum wheel
precautions” in Section 7−2.