’01 TUNDRA_U (L/O 0008)
103
2001 TUNDRA (OM34416U)
Use the front drive control lever to se-
lect the following transfer modes.
“H2” (high speed position, two–wheel
drive): Lever at “H2”
Use this for normal driving on dry, hard–
surfaced roads. This position gives greater
economy, the quietest ride and least wear.
“H4” (high speed position, four–wheel
drive): Lever at “H4”
Use this for normal driving on wet, icy or
snow–covered roads. This position pro-
vides greater traction than two–wheel
drive.
“N” (neutral position): Lever at “N”
No power is delivered to the wheels. The
vehicle must be stopped.
“L4” (low speed position, four–wheel
drive): Lever at “L4”
Use this for maximum power and traction.
Use “L4” for climbing or descending steep
hills, off–road driving, and hard pulling in
sand, mud or deep snow.
The “4WD” (four–wheel drive) indicator
light comes on when the “H4”, “N” or “L4”
mode is selected.
See “(c) Shifting procedure (lever type)”
for further instructions.
Four–wheel drive system—
(a) Front drive control
(lever type)
(a) Front drive control
(button type)
To Next Page
Loading...
Need help?
General
