TOYOTA TUNDRA 2016 - TONNEAU COVER
Preparation
Page 1 of 11 pages
Issue: C 04/18/2017
DIO
Part Number:
PU100-3415S-01, PK3B1-34H5H (Short)
PU100-3415R-01, PK3B1-34H6H (Reg.)
PU100-3415L-01, PK3B1-34H8H (Long)
Kit Contents
Item # Quantity Reqd. Description
1 1 Tonneau Cover
2 2 Side Rails (1 left, 1 right)
2 Drain Tubes
4 1 Hardware Bag
Hardware Bag Contents
Item # Quantity Reqd. Description
1 1 User Manual
2 1 Clamp Bracket
(10pc Short Bed, 12pc Regular
Bed, 16pc Long Bed)
3 1 T30 Torx, M6 x 1.0 x 30mm
Mounting Hardware
(10pc Short Bed, 12pc Regular
Bed, 16pc Long Bed)
4 1 Foam Seal Roll
5 1 Hex Key
Additional Items Required For Installation
Item # Quantity Reqd. Description
1 1 Bed Rails (if the vehicle is not
already equipped)
2
3
Conflicts
Bed Divider (PT767 34070) & Bed Liners that are not
compatible with Toyota accessory rails
GoPro® mount
General Applicability
All Tundra models with accessory bed rails
Recommended Sequence of Application
Item # Accessory
1 Bed Liner
2 Tonneau Cover
3 Accessory Rails
*Mandatory
Recommended Tools
Personal & Vehicle
Protection
Notes
Safety Glasses
Wrist & Belt Buckle
Protection
Special Tools Notes
Installation Tools Notes
Torx Socket T-30 (Hardened), 3/8” Drive
Torque Wrench 200 N-m, 150 in-lbf, 3/8”
Drive
Ratchet 3/8” Drive
Ratchet Extension Short, 3/8” Drive
Drill
Drill Bit 3/4” dia.
Tape Measure
Scissors
Screwdriver Phillips #2
Plastic Mallet
Special Chemicals Notes
Vehicle Service Parts (may be required for reassembly)
Item # Quantity Reqd. Description
1
2
3
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
SAFETY TORQUE: This mark indicates that torque is
related to safety.
To Next Page
Need help?
General
