Trane NTXAMT A Series User Manual

OPERATING PROCEDURE PHOTOS/FIGURES
1. Removing the cabinet and the panels
(1) Remove all the screws of the service panel, and remove
the service panel.
(2) Disconnect the power supply cord and indoor/outdoor
connecting wires.
(3) Remove all the screws of the top panel, and remove the
top panel.
(4) Remove all the screws of the cabinet, and remove the
cabinet.
(5) Remove all the screws of the back panel, and remove the
back panel (Photo 3).
94
DISASSEMBLY INSTRUCTIONS
12
12-1. NTXMMX20A122AA
NOTE: Turn OFF the power supply before disassembly.
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are following 2 types of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector shown below
has the locking mechanism.
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
Sleeve
Locking lever
Photo 2
Photo 1
Screws of the cabinet
Screws of the
top panel
Screws of
the cabinet
Screws of
service
panel
Screws of the
top panel
Screws of
the cabinet
Screws of
the cabinet
Screws of the
sub panel
Photo 3
Screw of the rear guard
Screws of the
back panel
Screws of the
back panel
Screws of
the back panel
OBHT702

Trane NTXAMT A Series Specifications

General

Brand	Trane
Model	NTXAMT A Series
Category	Air Conditioner
Language	English