OPERATING PROCEDURE PHOTOS/FIGURES
3. Removing the fan motor
(1) Remove the service panel (Photo 1).
(2) Disconnect the power supply cord and indoor/outdoor
connecting wires.
(3) Remove the top panel, the cabinet, and the back panel
(Photo 1, 2, 3).
(4) Disconnect the connectors of CN712, CNF1, CNTH1,
CNTH2, CN63H, CN791, CN792, CN793, CN794, CN797
on the outdoor control P.C. board and disconnect the
relay connector of the compressor lead wire.
(5) Remove all the screws of the electrical box assembly, and
remove the electrical box assembly (Photo 4).
(6) Remove the propeller fan.
(7) Remove the fan motor.
NOTE: The propeller fan nut is a reverse thread.
Photo 8
4. Removing the compressor and the 4-way valve
(1) Remove the service panel (Photo 1).
(2) Disconnect the power supply cord and indoor/outdoor
connecting wires.
(3) Remove the top panel, the cabinet, and the back panel
(Photo 1, 2, 3).
(4) Recover gas from the refrigerant circuit.
NOTE: Recover gas from the pipes until the pressure
gauge shows 0 kg/cm
2
(0 MPa).
(5) Disconnect the outdoor control P.C. board connectors:
CNF1, CNTH1, CNTH2, CN63H, CN791,CN792, CN793,
CN794, CN797, CN712.
(6) Disconnect the compressor lead wire from the terminal of
the compressor (U, V, W).
(7) Remove all the screws of the electrical box assembly, and
remove the electrical box assembly (Photo 4).
(8) Remove the propeller fan.
(9) Remove the sound proof felt
, and .
(
10
) Remove all the screws of the separator, and remove the
separator.
(
11
) Detach all the brazed parts of the compressor suction and
discharge pipes.
(
12
) Remove all the compressor nuts and remove the com-
pressor.
(
13
) Detach all the brazed parts of the 4-way valve and pipe.
96
Sound
proof
felt *2
Photo 9
R.V. coil
4-way valve
LEV coil R
Expansion valve R
Suction pipe
brazed part
Discharge pipe
brazed part
Compressor nuts
4-way
valve
R.V. coil
Photo 10
Brazed parts
Screws of the outdoor fan motor
Propeller fan
Propeller
fan nut
Separator
Sound
proof felt
Sound
proof
felt
Sound
proof
felt
To Next Page
Loading...
Need help?
General
