15 48663967 Rev 1
Contents
2.4.1.2. Remote and Indoor Unit range
Range (Indoor) Range (Outdoor - without any obstacles)
14 meter 160 to 175 meter
2.4.2. Functions
2.4.2.1. TRANE Mode
1. Press to start or stop TRANE mode (Refer Figure - 7).
2. The unit when powered ON by remote control starts with TRANE mode by default.
3. The TRANE mode will set room temperature and fan speed automatically to provide
an energy ecient and comfortable environment hence the energy eciency
meter always shows dark green (Refer Figure - 5)
4. It will set room temperature automatically based on outdoor temperature.
5. Unit shall exit ‘TRANE mode’ if user changes any of the following: set point, fan speed, mode, sleep and
also if button is pressed.
6. Unit will not exit ‘TRANE mode’ if user changes any of the following:
swing button, multi room or night latch button.
7. The indication of TRANE mode is button with red back light and the remaining buttons with light
OFF. The back light will go OFF after 20 seconds from last operation of remote controller.
2.4.2.2. Cool Mode
Figure - 8
COOL
DRY
FAN
e
1 2 3
Display
1. Press MODE to select cool mode, see ‘COOL’ shown on display (Refer Figure - 8).
2. Press to set fan speed (if required)
3. Press or to increase or decrease set temp. Set temperature range is 17°C - 30°C.
This is normal mode of cooling. User can set room temperature and AC will run to
attain the set temperature.
Temperature can be set based on energy consumption, Refer below table
Zone 1 - Red Uneconomical
Zone 2 - Yellow Higher energy consumption
Zone 3 - Light green Economical
Zone 4 - Dark green Lower energy consumption
2.4.2.3. Dry Mode
1. Press MODE to select dry mode, see ‘DRY’ shown on display
(Refer Figure - 10).
In dry mode default set temperature is 25°C.
Set temperature and fan speed cannot be changed.
Unit will operate at low fan speed for maximum moisture removal.
Figure - 7
e
To Next Page
Loading...
Need help?
General
