Rest for 5 minutes before
measuring.
Wait at least 3 minutes between
measurements. This allows your
blood circulation to recover.
For a meaningful comparison,
try to measure under similar
conditions. For example, take daily
measurements at approximately
the same time, on the same arm,
or as directed by a physician.
Tie the Cuff
1.Tie the cuff on your upper arm,
then position the tube off-center
toward the inner side of arm in
line with the little finger.
2.The cuff should be snug but not
too tight. You should be able to
insert one finger between the
cuff and your arm.
3.Sit comfortably with your tested
arm resting on a flat surface.
2~3cm
4.Repeat steps 2 and 3 to set the [MONTH] and [DAY].
5.Repeat steps 2 and 3 to set the [HOUR] and [MINUTE].
6.Repeat steps 2 and 3 to set the [UNIT].
7.After the unit is set,the right picture
will show,then it turn off .
START STOP
TESMEM
START STOP
TESMEM
START STOP
TESMEM
START S
TOP
TESMEM
START STOP
TESMEM
START STOP
TESMEM
START STOP
TESMEM
START STOP
TESMEM
START
STOP
TESMEM
START
ST
OP
TESMEM
98
MEASUREMENTBEFORE YOU START
To Next Page
Loading...
Need help?
General
