165
15
4. After the measurement, it will repeat the data
transmission steps as described on pape 14.
When the “TRIPLE MODE” buton is located on “ON”, the monitor is under the Triple
Measurement mode.
1.When the monitor is off , press the
“START/STOP” button to turn on, and then it will
complete the whole measurement automatically.
2.When the first measurement is done, it won’t show
the readings. It will start the second measurement after
60 seconds.
3. Then it will repeat the steps to finish the third
measurement. When three measurements are done,
the LCD will display the average of 3 readings.
Tip:
If the measurement fails in the process of 3 munimes, it will report
an error and repeat the current measurement. If the error
occurs for 2 times in a row, the mode of 3 times measurement will be
automatically quit.
Tip:
You can press the “START/ STOP” button to stop the measurement
any time.
MEASUREMENT MEASUREMENT
B: Using Triple Measurement Mode
Display the zero point Inflating and measuring
LCD display
To Next Page
Loading...
Need help?
General
