Maintenance
119
To lubricate the drive chain:
• Use the special drive chain
lubricant as recommended in the
Specifications section.
• Apply lubricant to the sides of the
rollers then allow the motorcycle
to stand unused for at least eight
hours (overnight is ideal). This will
allow the lubricant to penetrate to
the drive chain O-rings etc.
• Before riding, wipe off any excess
lubricant.
• If the drive chain is especially dirty,
clean first and then apply lubricant
as mentioned above.
Caution
Do not use a pressure washer to
clean the drive chain as this may
cause damage to the drive chain
components.
Drive Chain Free Movement
Inspection
Warning
Make sure the motorcycle is stabilised
and adequately supported.
A correctly supported motorcycle will
help prevent it from falling.
An unstable motorcycle may fall,
causing injury to the operator or
damage to the motorcycle.
1
1. Maximum vertical movement position
To inspect the drive chain free
movement:
• Place the motorcycle on a level
surface and hold it in an upright
position with no weight on it.
• Rotate the rear wheel by pushing
the motorcycle to find the position
where the drive chain is tightest,
and measure the vertical movement
of the drive chain midway between
the sprockets.
• The vertical movement of the drive
chain must be in the range 32 -
42 mm.
To Next Page
Loading...
Need help?
General
