EasyManuals Logo
Home>Troy-Bilt>Tiller>12211

Troy-Bilt 12211 User Manual

Troy-Bilt 12211
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
Section
5
Maintenance
REQUIRED MAINTENANCE SCHEDULE
Before Every Every As
PROCEDURE Each 10 30 Noted
Use Hours Hours
Check engine oil level
And every 5
operating hours
Clean engine
Check drive belt tension
Check nuts and bolts
Change engine oil
*
Lubricate tiller
Service foam pre-cleaner air filter
(if so equipped)
Service paper air filter
(if so equipped)
Check gear oil level in
transmission
Check tines for wear
Check air pressure in tires
Service spark plug
* Change more frequently in dusty or dirty conditions. Change after first 2 hours of
break-in operation.
Check after first 2 hours of break-in operation.
See Engine Owner’s Manual for service recommendations.
Before inspecting, cleaning or
servicing the machine, shut off engine,
wait for all moving parts to come to a
complete stop, disconnect spark plug
wire and move wire away from spark
plug. Remove ignition key on electric
start models.
Failure to follow these instructions can
result in serious personal injury or
property damage.
WARNING
TILLER LUBRICATION
Proper lubrication of the tiller is an essen-
tial part of your maintenance program.
After every 10 operating hours, oil or
grease the lubrication points shown in
Figure 5-1 as described below.
Use a good quality lubricating oil (#30
weight engine oil is suitable) and a good
quality general purpose grease (grease
that has a metal lubricant is preferred, if
available).
Remove wheels, clean wheel shaft (A,
Figure 5-1) and apply thin coating of
grease to shaft.
Grease back, front and sides of depth
regulator lever (B, Figure 5-1).
Remove tines, clean tine shafts (C,
Figure 5-1) and inspect for rust, rough
spots or burrs (especially around holes).
File or sand smooth and coat ends of
shaft with grease.
Oil the threads on the handlebar height
adjustment handle (D, Figure 5-1).
Oil the outer casings of the engine throt-
tle cable and the wheel gear cable (E,
Figure 5-1). Allow oil to soak in and
then wipe off any excess.
Oil the threads on the handlebar attach-
ing screws (F, Figure 5-1).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Troy-Bilt 12211 and is the answer not in the manual?

Troy-Bilt 12211 Specifications

General IconGeneral
BrandTroy-Bilt
Model12211
CategoryTiller
LanguageEnglish

Related product manuals