7
2. Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing plastic accessory tray.
3. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports (Figure 2).
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
4. Insert “L” bolt through hole on right side of handle
(viewing from rear of unit) and attach plastic knob.
Tighten the knob by hand (Figure 3).
5. Insert carriage bolt through left side hole from outside
of unit and attach a plastic knob from inside of unit
(viewing unit from rear). Tighten by hand (Figure 3).
6. Insert the “J” hook into the second from the left slot
in the accessory tray (Figure 4).
7. Pinch chemical hose and slide it into metal clip as
shown in Figure 5.
8. Tilt unit up by handle and attach metal clip to rib on
center underside of accessory tray (Figure 6). Slide
chemical hose through metal clip so that it is tight but
not kinked.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine owner’s manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine owner’s manual for recommendations.
Figure 3 — Secure Handle
Figure 4 — Install “J” Hook on Accessory Tray
Figure 5 — Slide Chemical Hose into Metal Clip
Figure 6 — Slide Metal Clip onto Accessory Tray Flange
Align Holes
Handle
Handle
Supports
Figure 2 — Attach Handle to Base
Section 3: Assembly
CAUTION
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
To Next Page
Loading...
Need help?
General
