Troy-Bilt Pro-Line CRT Service Manual

Troy-Bilt Small Frame Tillers
33
SUPER BRONCO TILLER
ABOUT THIS SECTION:
NOTE: This section covers the Super Bronco
Tiller, model 21A-634B063 with serial number
1B012G80125. This section has been techni-
cally written to follow along with the Troy-Bilt
Factory School. In addition, the Super Bronco
uses the same transmission as the Tuffy Tiller.
Therefore, the following information only covers
the subjects that are not covered in the Tuffy
Tiller section of this book. If you need additional
information, refer to the Tuffy Tiller section.
UNIT FEATURES:
• 6.5 Hp, 4 cycle engine. See the Image Below.
• Protective bumper
• Power forward and reverse
• 16” tilling width
• 10” tine diameter
• Adjustable tilling depth up to 6”
• 13” Agricultural tires
Engine and Protective Bumper
Protective Bumper
13” Ag. Tires
1. REVERSE CLUTCH CABLE REPLACEMENT:
1.1. Locate the reverse clutch cable at the upper
handlebar. See Figure 1.1.
1.2. Remove the front jam nut securing the reverse
clutch cable to the upper handlebar bracket
using a 7/8” wrench. See Figure 1.2.
1.3. Remove the reverse clutch cable from the upper
handlebar bracket.
Figure 1.1
Reverse Clutch Cable
Upper Handle Bar
Figure 1.2
Jam Nut
Upper Handle
Bracket

Troy-Bilt Pro-Line CRT Specifications

General

Brand	Troy-Bilt
Model	Pro-Line CRT
Category	Lawn and Garden Equipment
Language	English