Troy-Bilt Pro-Line CRT Operator's Manual

Maintenance& Adjustments
MaintenanceSchedule
Check After
first 2 hours
Before each
use
Every
5 Hours
Every
10 Hours
Every
30 Hours
See Engine
Manual
CheckMotorOilLevel _
CleanEngine _
CheckDriveBeltTension _
CheckNutsandBolts M/ M/
LubricateTiller
CheckGear0il LevelinTransmission V /
CheckTinesfor Wear VII
CheckAirPressureinTires V /
WARNING! Before inspecting, cleaning or servicing
the machine, shut off the engine, wait for all moving
parts to come to a complete stop, disconnect the
spark plug wire and move the wire away from the
spark plug. Failure to follow these instructions can
result in serious personal injury or property damage.
Maintenance
Engine
Refer to the Engine Operator's Manual packed with your tiller for
all engine maintenance.
TirePressure
Check the air pressure in both tires. The air pressure should be
between 1,5-20 PSI. Keep both tires equally inflated to help
prevent machine from pulling to one side.
Hardware
Checkfor loose or missing hardware after every 10 operating
hours and tighten or replace (asneeded) before using tiller
Besure to check the screws underneath the tiller hood that
secure the transmission cover and the Depth Regulator Lever to
the transmission.
Lubrication
After every 10 operating hours, oil or grease the lubrication
points shown in Fig. 6-1 and described below.
Handlebar / /
\ J
Figure 64
15

Troy-Bilt Pro-Line CRT Specifications

General

Brand	Troy-Bilt
Model	Pro-Line CRT
Category	Lawn and Garden Equipment
Language	English