Troy-Bilt RZT 50 User Manual

10
SLOPE GAUGE
(Keep this sheet in a safe place for future reference.)
15°
SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE
A POWER POLE
A CORNER OF A BUILDING
OR A FENCE POST
F
O
L
D
ON
D
O
T
T
E
D
L
I
N
E
,
R
E
P
R
E
SE
N
T
I
N
G
A
1
5
°
SL
OP
E
USE THIS PAGE AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELY.
WARNING
Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). A riding mower could overturn and cause serious injury. If operating a walk-behind mower on such a slope, it is extremely difficult to maintain your footing and you could slip, resulting in serious injury. Operate RZT zero turn tractors across the face of slopes rather than up and down. Begin with the first pass across the bottom of the slope and turn uphill at the end of each pass whenever possible.

Troy-Bilt RZT 50 Specifications

General

Engine Brand	Briggs & Stratton
Engine Model	Intek
Engine Displacement	724cc
Transmission	Hydrostatic
Blade Engagement	Electric PTO
Cutting Width	50 inches
Fuel Capacity	3 gallons
Deck Material	Steel
Warranty	3 years limited
Turning Radius	Zero-turn