7
3
Setting Up
Your Snow
Thrower
6. Remove the flat washer and hairpin clip from the end
of the chute directional control, Figure 3-5.
Insert the end of the chute directional control into the
lower bracket and secure with the flat washer and hair-
pin clip just removed. If necessary, the lower bracket
can be adjusted. Refer to Chute Bracket Adjustment in
the “Making Adjustments” section.
IMPORTANT: Prior to op-
erating your snow thrower,
refer to the Auger Control
Test in the Operations
section. Read and follow all
instructions carefully and
perform all adjustments to
verify your snow thrower
is operating safely and
properly.
Tire Pressure
Before operating, check tire pressure and reduce
pressure in both tires to between 15 psi and 20 psi.
NOTE: If the tire pressure is not equal in both tires, the
unit may not travel in a straight path and the shave plate
may wear unevenly.
Figure 3-5
IMPORTANT: Prior to operating your snow thrower, refer to Auger Control Test in the “Operating your Snow
Thrower” section. Read and follow all instructions carefully and perform all adjustments to verify your snow
thrower is operating safely and properly.
To Next Page
Loading...
Need help?
General
