22
OPERATION
HOLDING THE UNIT
• Stand in the operating position (Fig. 15). Stand up straight. Do not bend over.
• Keep feet apart and rmly planted.
• Hold the shaft grip with the right hand. Keep the right arm slightly bent.
• Hold the handle with the left hand. Keep the left arm straight.
• Hold the unit at waist level.
• Position the cutting head a few inches above the ground.
WARNING: Always wear eye, hearing, hand, foot and body protection to reduce the
risk of injury when operating this unit.
WARNING: To prevent serious personal injury, avoid arm contact with the engine
while operating the unit. The engine may be extremely hot.
Fig. 15
Fig. 14
Starting
Position
Throttle Control
Starter Rope Grip
To Next Page
Need help?
General
