EasyManuals Logo
Home>Troy-Bilt>Lawn Mower>TB30R

Troy-Bilt TB30R User Manual

Troy-Bilt TB30R
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
11Section 3 — ASSembly & Set-Up
Attaching the Seat
If the seat for your tractor was not attached at the factory, follow
the applicable instructions below to attach it.
1. Remove the shoulder bolts and lock nuts from the seat
mounting bracket included in your hardware pack. See
Figure 3-5.
Figure 3-5
2. Remove the two self-tapping bolts factory installed on the
tractor. See Figure 3-6.
Figure 3-6
3. With the steering wheel assembly upright and positioned
over the lower steering shaft on the tractor, align the
steering wheel so that with the tractor wheels straight, the
large opening on the steering wheel is facing forward.
4. Lower the steering wheel assembly onto the lower steering
shaft and secure with the shoulder bolt and lock nut
previously removed. See Figure 3-3.
1
2
2
Figure 3-3
5. Tighten the shoulder bolt and lock nut using a 9/16
wrench or socket and 7/16”wrench or socket.
6. Remove the pedestal cap mount screw factory installed
and located on the tractor’s steering console. Retain the
screw for later instructions.
7. Slide the pedestal cap down onto the tractor and connect the
headlight as shown in the inset of Figure 3-4 (1) and slighty
rotate to the right to clip into place. Secure the pedestal with
the screw (2) previously removed. See Figure 3-4.
1
2
Figure 3-4
11

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Troy-Bilt TB30R and is the answer not in the manual?

Troy-Bilt TB30R Specifications

General IconGeneral
BrandTroy-Bilt
ModelTB30R
CategoryLawn Mower
LanguageEnglish

Related product manuals