4.2 Mechanism Fine Adjustment to Avoid Ribbon Wrinkles
Ribbon wrinkle is related to the media width, thickness, print head pressure balance, ribbon film characteristics, print darkness
setting…etc. In case the ribbon wrinkle happens, please follow the instructions below to adjust the printer parts.
Wrinkle happens from label lower right to upper left direction
Switch the ribbon tension adjustment knob clockwise per 1 level and print the label again to check if the wrinkle is gone.
If the tension adjustment knob has positioned on the level of innermost side but does not improve the ribbon wrinkle, please switch
the print head pressure adjustment knob per level and print the label again to check if the wrinkle is gone.
If the wrinkle can’t be avoided, please contact the Customer Service Department of your purchased reseller or distributor for
service.
To Next Page
Loading...
Need help?
General
