TSC TTP-368MT Series Service Manual

47
Adjust the print head pressure adjustment knob
The print head pressure adjustment knob has 5
levels of settings. Clockwise direction adjustment
is to increase the print head pressure. Counter
Clockwise adjustment can decrease the print head
pressure.
If the wrinkle on the label starts from the lower left
side to upper right side, please do following
adjustment.
1. Decrease the right side print head pressure
adjustment knob setting 1 level per each
adjustment then print the label again to check if
wrinkle is gone.
2. If the right side print head adjustment knob
setting has been set to index 1 (the lowest
pressure index), please increase the left side
print head pressure.
3. If the left side print head adjustment knob
setting has been set to 5 (the highest pressure
index) the wrinkle can’t be avoided, please
increase the middle print head pressure knob.
4. If the wrinkle can’t be avoided, please refer to
next chapter to adjust the Z-axis mechanism
adjustment knob.
Pressure knob adjustment reference:
 6” label
Left index
Middle index
Right index
2
1
1
3
1
1
4
1
1
5
1
1
5
2
1
5
3
1
5
4
1
5
5
1
 3” label
Left index
Middle index
Right index
2
2
1
3
3
1
4
4
1
5
5
1
Adjust the print head pressure adjustment knob
The print head pressure adjustment knob has 5
levels of settings. Clockwise direction adjustment is
to increase the print head pressure. Counter
Clockwise adjustment can decrease the print head
pressure.
If the wrinkle on the label starts from the lower right
side to upper left side, please do following
adjustment.
1. Decrease the left side print head pressure
adjustment knob setting 1 level per each
adjustment then print the label again to check if
wrinkle is gone.
2. If the left side print head adjustment knob level
has been set to index 1 (the lowest index), please
increase the right side print head pressure.
3. If the right side print head adjustment knob setting
has been set to 5 (the highest pressure index) the
wrinkle can’t be avoid, please increase the middle
print head pressure knob.
4. If the wrinkle can’t be avoided, please refer to
next chapter to adjust the Z-axis mechanism
adjustment knob.
Pressure knob adjustment reference:
 6” label
Left index
Middle index
Right index
1
1
2
1
1
3
1
1
4
1
1
5
1
2
5
1
3
5
1
4
5
1
5
5
 3” label
Left index
Middle index
Right index
1
2
2
1
3
3
1
4
4
1
5
5
Left knob
Right knob
Middle knob
Middle knob

TSC TTP-368MT Series Specifications

General

Brand	TSC
Model	TTP-368MT Series
Category	Printer
Language	English