Note: If printing from enclosed software/driver, the software/driver will send
out the command, which will overwrite the setting set from the front
panel.
3.1.1.5 Offset:
Print Setup 5/12
Direction
Print Mode
> Offset
Offset
+000
20
This option is used to fine tune media stop location. Press the button to
move the cursor from left digit to right digit, and press the button to set the
value from “+” to “-” or “0” to “9”. Press the button to set the value into
printer. Press key to cancel the setting and return to the previous menu.
The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send
out the OFFSET command, which will overwrite the setting set from
the front panel.
3.1.1.6 Shift X & Shift Y:
Print Setup 7/12
Offset
Shift X
> Shift Y
Shift Y
+000
This option is used to fine tune print position. Press the
button to move
the cursor from left digit to right digit, and press the
button to set the value
from “+” to “-” or “0” to “9”. Press the button to set the value into printer.
Press key to cancel the setting and return to the previous menu. The
default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send
out the SHIFT command, which will overwrite the setting set from the
front panel.
3.1.1.6 Reference X & Reference Y:
Print Setup 9/12
Shift Y
Reference X
> Reference Y
Reference Y
000
To Next Page
Loading...
Need help?
General
