TurboChef TORNADO Quick Guide

Bracket
Flat Washer
Split Lock Washer
Nut
Bolt
Flat Washer
High h Batch (Figure 2)
Tornado or C3 (Figure 1)
DOC-1032/Revision F/
February 2013
Bracket
Flat Washer
Split Lock Washer
Nut
Bolt
Flat Washer
Encore (Figure 3)
Stacking
Bracket
Outer Holes = Tornado
Inner Holes = C3
Split Lock
Washer
Flat Washer
Bolt
Securing Tornado, C3, High h Batch, and
Encore Ovens to an Oven Cart
FOR ALL OVENS:
1. Unplug the oven.
2. Lock the wheels of the oven cart.
NOTE: For additional skid prevention of C3 and Tornado ovens, place a
TurboChef sorbothane stacking mat (part number NGC-1342-1) on the cart,
aligning the edges of the mat with the edges of the cart.
3. Place the oven on the oven cart.
WARNING: Do not attempt to lift the oven with fewer than 2 people.
WARNING: When lifting, position at least one person on each side.
WARNING: Do not lift the oven from the front and back.
WARNING: Do not lift the oven by the door handle.
FOR TORNADO & C3 ONLY: FIGURE 1
4. If the oven is a C3 or Tornado, remove the legs. There will be holes in the
oven where the legs used to be.
5. Align the oven holes with the oven cart holes. (Dierent sets of holes are
provided on cart to accommodate either the Tornado or C3 - see Figure 1.)
6. Install bolts with washers by running them up through the cart surface
and into the holes in the oven (where the legs were).
FOR HIGH H BATCH FIGURE 2 AND ENCORE FIGURE 3:
4. Attach one oven cart bracket to each leg (part number HHB-8206
includes four brackets).
5. Secure each leg by aligning the bracket with the holes on the oven
cart and attaching the parts listed in Figure 2 for the High h Batch and
Figure 3 for the Encore.
NOTE: Ensure the nut is securely tightened.

TurboChef TORNADO Specifications

General

Brand	TurboChef
Model	TORNADO
Category	Oven
Language	English