Tylo Sense Combi-U 7 User Manual

2018-01-02
2900 5262
SENSE COMBI PURE Quick-Start Tip Sheet
This page to be used in conjuction with Tylo Full Manual included
CONNECTION/WIRING DIAGRAM
TAB 208 V 1 Phase 240 V 1 Phase
Model Amperage
Amps
Output
kW
Wire Size
AWG
Amperage
Amps
Output
kW
Wire Size
AWG
Sense Combi-U 7 26
5.3
10 30
7.0
8
Sense Combi-U 8 30
6.3
8 35
8.3
8
Note: Heating elements do not change for voltage changes. The heater output will change
based on the voltage applied to heater. Most North American homes are 240v.
10
1415
6
12
13
11
14
RJ10 4P4C
3 x 14 AWG
RJ10 4P4C
RJ10 4P4C
RJ10 4P4C
m
ax 300 feet - Combi Pure
*
**
BB4140
12
6789
34 5
120 V~
14 AWG
Max. 6 Amp.
5.3-8.3 kW
208/240 V~
G
Connect Control cable to
jack 9 on circuit board.
Connect NTC Sensor cable
to jack 1 on circuit board.
Sensor Installation Tip
Sensor with metal tab can usually installed without cov-
er with one screw through the sensor tab directly to the
¿QLVKHGZDOO
If using Sensor Cover, you must feed the sensor wire
through the sensor holder FIRST before putting sensor
wire in the wall.
Figure 19: Wiring diagram
1. NTC Sensor - Combi Pure.
2. Ext switch (External switch Optional)
3.
Door jumper pre-installed in terminal #3.
(Door contact not required for N America)
4.-8.
N/A
9.
Pure Control
10. Heater
11. Terminal for connection of electrical cable
12. Control panel (connect to position 9)
13. Sensor - Combi Pure (connect to NTC
terminal #1)
14.
Light/terminal for connection of light.
(requires separate 120v supply)
15.
Door Contact not required for N America
16. External switch (option)
In order for control
to operate light, a
separate 120V supply
must be provided and
connected to heater
Field Connect three
copper conectors
x3

Tylo Sense Combi-U 7 Specifications

General

Brand	Tylo
Model	Sense Combi-U 7
Category	Electric Heater
Language	English