UNI-T UDP3305S-E User Manual

UDP3305S Series Programmable DC Power Supply User Manual
computer software
UNI-T’s official website.
Alligator clip test leads
2
USB cable
1
3.12 Requirements for Power Supply
UDP3305S series can only be used in following conditions:
Parameters
Requirements
Voltage
AC 100V/120V/220V/230V±10%
Frequency
50/60Hz
Power
MAX 600W
Fuse
AC220V input voltage: T4AL250V
AC110V input voltage: T8AL250V
 Three-core power cord is provided. Please make sure that the ground wire of three-phase socket is properly
grounded before use.
 250V/4A (5x20mm) fuse is selected and installed for the instrument (220V) with a spare fuse in the fuse case.
 When replacing the fuse, please remove the external power cord first, then open the fuse slot under the
power interface, take out the old fuse and replace it with a new one, and install the fuse slot back after
completion.
Warning: Please do not use the damaged power cord.
3.13 Operating Environment
UDP3305S series can only be used in normal temperature and low condensing zone. The general environment
requirements are listed as follows.
Environment
Requirements
Operating temperature
0°C~40°C
Operating humidity
20%~80% (non-condensing)
Storage temperature
-10°C~60°C
Altitude
≤2000m
Degree of pollution
II
3.14 Cleaning
To avoid electric shock, please unplug the power cord before cleaning.
Clean the housing and the panel with a soft damp cloth, and make sure it is completely dry.
Note: Do not use solvents like alcohol and gasoline.

UNI-T UDP3305S-E Specifications

General

Brand	UNI-T
Model	UDP3305S-E
Category	Power Supply
Language	English