To minimize the effect of capacitance stored in the test
clips, the test clips should be as short as possible and
use the small value jack when measuring small value of
capacitance.
The Meter cannot check the quality of the capacitor.
For large capacitor, please make sure the contact is
stable and reliable.
When the tested capacitor is leaking or damaged and
the tested value is not stable, the capacitor may have
problems. You need to use other tools or equipment to
check and confirm.
When capacitance measurement has been completed,
disconnect the connection between the testing clips and
the circuit under test and remove the testing clips away
from the input terminals of the Meter.
l
l
l
l
16
Model UT602/603: OPERATING MANUAL
Note
To Next Page
Loading...
Need help?
General
