UNI-T UT602 User Manual

To measure transistor, set up the Meter as follows:
Set the rotary switch to hFE measurement mode.
Check that the transistor is PNP or NPN type.
Insert the Insert the transistor to be measured to the
corresponding Transistor Jack
The Meter displays the tested transistor’s nearest value
When transistor measurement has been completed,
disconnect the connection between the testing clips and
the circuit under test and remove the testing clips away
from the input terminals of the Meter.
l
18
Model UT602/603: OPERATING MANUAL
E. Transistor hFE Measurement (see figure 7)
(figure 7)
1.
2.
3.
4.
Note:

UNI-T UT602 Specifications

General

Brand	UNI-T
Model	UT602
Category	Measuring Instruments
Language	English