Warning
T
o avoid harms to you or damages to the Meter from electric shock, please do
not attempt to measure voltages higher than 1000V although readings may be
obtained.
When measuring high voltage, take extra care to avoid electric shock.
1. Insert the red test lead into the V terminal and the black test lead into the COM
terminal.
2. Set the rotary switch to V; DC measurement is default or press BLUE button to
switch between DC and AC measurement mode.
3. Connect the test leads across with the object being measured. The measured
value shows on the display.
UT61A, UT61B and UT61C: display effective value of sine wave (mean value
response).
UT61D and UT61E: display true rms value.
4. Press Hz% to obtain the frequency and duty cycle value.
Input Amplitude: (DC electric level is zero)
Input Amplitude: range 30%
Frequency respouse:UT61A and B 400Hz
UT61C,UT61D and UT61E 1KHz
Model UT61A/61B/61C/61D/61E: OPERATING MANUAL
16
To Next Page
Loading...
Need help?
General
